2Relay-HC (High Current Outputs)

Convert 'HMS 12 Volt Drivers' to Relay Contacts

2 Isolated outputs (Relays)    

2Relay-HC (High Current)

Features:

• small footprint (3.2 x 3.0 inches)
• Connect to any HMS board with drivers to convert from 12 volt logic drive to isolated contacts
• 2 Relays for Outputs (Normally Open contacts only)
• LED's to indicate relay is powered!
• Includes voltage snubber networks' for EMI/RFI noise reduction.
• Use the 12Volt power on the HMS board to drive the relays

Outputs:

These relays are used to supply RELAY CONTACTS to remote devices or lamps.  U.L. Single Contact Ratings: 10 amps 120/250VAC (resistive).  The relays can switch AC or DC (8 AMPS 30VDC).  Important:  Reduce the maximum current by 50% for HIGHLY inductive loads.

The input power terminal block is rated for 20 amps and the circuit board has 6 oz copper (very heavy copper traces).  Each output relay and terminal block can supply 10 amps.  Combined, the maximum current is about 18 amps (both relays on).

Last Revised: 08/27/2024